Marine black water holding tank pump out/flush system for DIY into home sewer

Description

Blackwater Bazooka by
Sixo Design
Assembled and Sold in the USA
(please note that we build these units in limited quantities which are dependent on
availability
of materials so keep checking this offer. I
f the orientation of the fittings or sizes don't match your needs we will change them to suit your vessel. Just make contact with us any time and we will make it work as customer satisfaction is our priority.
I also sell these direct at a lower price than listed here. Make contact with me for details. Email address is below.
Pump out and rinse your boat holding tanks with the Blackwater Bazooka. This device is clean and simple to use. You will not be limited to using public pump out stations on the water. Pump out can be done at home into a portable container, your own sewer/septic system (via a floor drain, vent pipe), or directly into a toilet bowl. It does not require alterations to your boat. All you need is pressurized clean water for rinse (common garden hose bib or on board wash down system), a 12 volt D/C power source (vessels' battery or for best performance and simplicity a dedicated deep cycle marine battery with carrying handle). Once attached to the waste fitting the fresh water hose initiates a hydro blast to dislodge and suspend solids at the bottom of the tank for more efficient and complete evacuation of the waste.This will
clear
sensors and gauge float components.
I also sell these units direct at a reduced price. Just email the address below for details.
Operates in both vertical or horizontal positions.
Voltage: 12 volts DC
Flow: 12 gallons per minute (free flow)
Power draw: 7.0 amps
liquefy and pump waste up to distance of 100 feet with a rise of 7 feet
Self-priming capabilities: 5 feet vertical suction lift
Inlet: 1.5 inch
System adapts to 1.25" and 1.5" vessel WASTE ports (both fitting included)
Output: 3/4 inch male garden hose
25 foot Fresh water rinse input and 12 foot waste output hoses included
Run-dry safe (short duration)
Quad blade chopping design
Ignition protected
Built-in thermal protection
Impeller: rubber and copper
Capability to manually turn shaft with screwdriver or reverse cap if ever clogged
Triple sealed motor to prevent internal and external corrosion
See the YouTube videos for demonstrations of the system in action
Blackwater Bazooka Macerator pump out kit for boats with holding tanks - YouTube
Paste link below into browser