ANDERIC FAN35T/FAN30R Ceiling Fan Remote Control Kit for Harbor Breeze 303.9 mhz

Description

You are buying: ANDERIC FAN35T/FAN30R Ceiling Fan Remote Control Kit ANDERIC FAN35T-FAN30R-KIT
Models Originally Supplied with:
**Models listed may not be a full list. Please email us if you do not see your model.
Compatible Device Type:
**Models listed may not be a full list. Please email us if you do not see your model.
Product Details:
The Anderic FAN35T-FAN30R-KIT will replace your original Harbor Breeze FAN35T and FAN30R units.
Color: Ivory
ASSOCIATED NUMBERS:
FCC ID: L3HFAN35T for Harbor Breeze
303.9MHz Frequency
REQUIRES BATTERY TYPE:
23A12V
(NOT INCLUDED, YOU MAY ADD THE BATTERY TO CART FROM CART PAGE)
.
Programming instructions:
Below instructions is for Learning with the FAN30R receiver pairing:
A. Align “DIP” switches on any pattern on the FAN35T for Harbor Breeze remote.
B. Turn on the Ceiling Fan main power switch and within 30 seconds after Ceiling Fan power is on,
C. Then push the “Learn” key for 3 to 5 seconds on FAN35T for Harbor Breeze.
D. Then the Lights on the Ceiling Fan will blink 2 times (or fan speed turns to MEDIUM speed). It means your setting is good. Test the rest of the buttons to make sure they work.
-----
If above doesn't work, try pressing and holding the OFF and LIGHT keys simultaneously for up to 10 seconds, lights should blink to confirm pairing.
If you have a second fan with the same remote:
A. Align DIP switches on FAN35T for Harbor Breeze to a different pattern than the first fan.
B. C. D. steps are the same as above.
FAN30R RECEIVER INFORMATION:
The Anderic
FAN30R
Receiver for Harbor Breeze Ceiling Fans that require the U-shaped
FAN30R
receiver.
ATTENTION: WILL
NOT
REPLACE Dawnsun
FD30-H02R (FD30H02R)
or
FD40-H02R(FD40H02R)
Receiver MODELS
Specifications:
Model:
FAN30R
for Harbor
Breeze-190WA
Max. downlight tungsten 190 watts or max. ballast 190 VA non-dimmer
120v
/
60hz
max motor 1a ceiling fan only.
PAIRING WITH REMOTE
in order to pair this receiver with your remote you must:
Install the receiver and make sure power is going through the receiver.
On remote press and hold the pairing button inside the battery compartment for 5 seconds.
Lights on the fan will blink twice to confirm pairing successful.
SPECS
5 3/16" LONG
3 1/8" WIDE
1" THICK
MANUFACTURER INFORMATION
ANDERIC
FAN35T-FAN30R-KIT